Dinamica ECAM35X.55 - ECAM35X.75Common issuesMessage: Replace filter, ESC to cancel, OK to replace
Dinamica ECAM35X.55 - ECAM35X.75

Message: Replace filter, ESC to cancel, OK to replace

Try this solution

Replace the filter or remove it

Potential cause:
The water softener filter is exhausted.

Follow the guide below for instructions on how to replace the water filter:

How-to guide

1. Press OK if you want to replace the filter now


Otherwise, press ESC to replace later.

2. Extract the tank and exhausted filter

3. Take the new filter out of its packet

The date indicator disk varies according to the filter provided.

4. Turn the date indicator disk until the next 2 months of use are displayed

Please note:
The filter lasts about two months if the appliance is used normally.

5. To activate the filter:

Run tap water through the hole in the filter as shown until water comes out of the openings at the side for more than a minute.

6. Fill the tank with water

7. Insert the filter in the water tank and immerse it completely for about ten seconds, sloping it and pressing it lightly to enable the air bubbles to escape

8. Insert the filter in the filter housing and press as far as it will go

9. Close the tank with the lid, then replace the tank in the machine

10. Press the cogwheel button to enter the "Settings" menu

11. Press the selection arrows until "Maintenance" is displayed between the two lines

12. Press OK

13. Press the selection arrows until "Replace filter" is displayed between the two lines

14. Press OK

"Confirm?" is displayed.

15. Press OK


"Hot water, Confirm?" is displayed.

16. Position a container under the hot water spout (min. capacity: 500 ml)

17. Press OK


The appliance begins hot water delivery and the message "Please wait" is displayed.

After the flow of hot water stops, the appliance automatically resets to "Ready for coffee" status.

The new filter is now active and you can use the coffee machine.