Skip to Content
PrimaDonna Class
Message: INSERT INFUSER ASSEMBLY
Try this solution
Make sure the infuser is properly inserted
Possible cause:
The infuser has not been properly replaced after cleaning.
Follow this step-by-step guide:
1
Important
The infuser may not be extracted when the coffee machine is on.
2
Turn off the coffee machine
3
Remove the water tank
4
Open the infuser door positioned on the right side of the coffee machine
5
Press the 2 coloured release buttons inwards and at the same time pull the infuser outwards
6
Replace the infuser by sliding it onto the internal support, then push the PUSH symbol fully in until it clicks into place.
Please note:
If the infuser is difficult to insert, before insertion, squeeze the
two levers shown in the figure to make it smaller
7
Once inserted, make sure the two coloured buttons have popped out again
8
Close the infuser door
9
Put the water tank back
On this page