Skip to Content
PrimaDonna ESAM6620
Message: Replace water softener filter. Press "OK" to start
Try this solution
Press the selector corresponding to“ OK” to replace the filter, or ESC to carry out the procedure later
Possbile cause:
The water softener filter is exhausted.
Follow the step-by-step guide:
1
Press the settings menu
2
Select "Replace water filter" and press "Next"
3
Press "OK" to enter the guided procedure
4
Extract the water tank and exhausted filter
Press "Next" to continue.
5
Remove the new filter from the packaging and turn the date indicator to view the next two months
6
Please note:
The filter last about two months if the coffee machine is used normally. If the coffee maker is left unused with the filter installed, it will last a maximum of three weeks.
7
Press "Next" to continue
8
Activate the filter
To activate the filter, run tap water through the hole in the centre of the filter until it comes out of the openings at the side for more than a minute.
9
Extract the water tank and fill with water
10
Insert the filter in the water tank and immerse it completely for about ten seconds, sloping it and pressing it lightly to enable the air bubbles to escape
Press "Next".
11
Insert the filter in the housing and press as far as it will go
Press "Next".
12
Close the tank with the lid and put the tank back in the coffee machine
13
Insert the descaling spout
Press "Next".
14
Position an empty container with a minimum capacity of 0.5 litres under the descaling spout
Press "OK" to activate the filter. The coffee machine delivers hot water, then stops automatically.
15
Press "OK" to go back to the homepage
The filter is now active and you can use the coffee machine.
On this page