Skip to Content
Dinamica Plus
Message: REPLACE WATER FILTER PRESS OK TO START
Try this solution
Press the selector corresponding to OK to start descaling or ESC to descale later
Potential cause:
The water softener filter is exhausted.
Follow the guide below for instructions on how to replace the water filter:
1
Press the selector corresponding to OK if you want to replace the filter now
Otherwise, press ESC to replace later.
2
Extract the tank and exhausted filter
3
Take the new filter out of its packet
The date indicator disk varies according to the filter provided.
4
Press the cogwheel button to enter the "Settings" menu
5
Scroll through the menu items by pressing Next, until "WATER FILTER" is displayed
6
Press "WATER FILTER"
7
Turn the date indicator disk until the next 2 months of use are displayed
Please note:
The filter lasts about two months if the appliance is used normally.
Then, press next:
8
To activate the filter:
Run tap water through the hole in the filter as shown until water comes out of the openings at the side for more than a minute.
Then, press next:
9
Fill the tank with water
10
Insert the filter in the water tank and immerse it completely for about ten seconds, sloping it and pressing it lightly to enable the air bubbles to escape
Then, press next:
11
Insert the filter in the filter housing and press as far as it will go
Then, press next:
12
Close the tank with the lid, then replace the tank in the machine
13
Position a container under the hot water spout (min. capacity: 500 ml)
Then, press OK:
Delivery begins and stops automatically. The filter is now active and you can use the coffee machine.
On this page